Safe use of welding robots


Published:

2023-03-28

(1) During the teaching process, hold the teaching pendant in your hand at all times, and do not place it randomly. Put your left glove into the strap to avoid dropping it by accident. The cable should be placed in a position that is not easy to step on. Do not pull it hard during use, and leave a loose length. (2) The robot has pre-set some operating data and programs from the perspective of operator safety. Beginners should not enter these menus to make changes without permission, so as to avoid danger. operate. (3) If the robot encounters a dangerous situation during the operation, the emergency brake switch should be pressed in time to stop the robot to avoid personal injury or damage to objects. (4) After the program is compiled, use the tracking operation to run the program once, modify the track points line by line, check the walking track and various parameters are correct, unscrew the valve of the protective gas cylinder, and then press the light on the teaching pendant. Gas detection icon, adjust the flow meter without recognition result, generally at 15L/min, close the gas detection, and move the cursor to the starting point of the program. (5) Before welding, hang up the teach pendant, turn the key to the "Auto" side, turn on the smoke and dust removal equipment, and press the start button of the robot. When observing the arc, you should hold the mask to avoid being burned by the arc light due to naked eyes or exposed skin. If you find any abnormal welding, you should immediately press the stop button and make a record. (6) After finishing the operation, turn the key of the mode switch to the "Teach" side, turn off the dust collector equipment, turn off the gas valve on the protective gas cylinder, release the residual gas in the air pipe, return the robot to zero position, and exit the display. Teach the program, then turn off the power as required, arrange the control cables of the teach pendant, hang the teach pendant at the designated position, and leave after finishing the site.

(1) During the teaching process, hold the teaching pendant in your hand at all times, and do not place it randomly. Put your left glove into the strap to avoid dropping it by accident. The cable should be placed in a position that is not easy to step on. Do not pull it hard during use, and leave a loose length.
(2) The robot has pre-set some operating data and programs from the perspective of operator safety. Beginners should not enter these menus to make changes without permission, so as to avoid danger. operate.
(3) If the robot encounters a dangerous situation during the operation, the emergency brake switch should be pressed in time to stop the robot to avoid personal injury or damage to objects.
(4) After the program is compiled, use the tracking operation to run the program once, modify the track points line by line, check the walking track and various parameters are correct, unscrew the valve of the protective gas cylinder, and then press the light on the teaching pendant. Gas detection icon, adjust the flow meter without recognition result, generally at 15L/min, close the gas detection, and move the cursor to the starting point of the program.
(5) Before welding, hang up the teach pendant, turn the key to the "Auto" side, turn on the smoke and dust removal equipment, and press the start button of the robot. When observing the arc, you should hold the mask to avoid being burned by the arc light due to naked eyes or exposed skin. If you find any abnormal welding, you should immediately press the stop button and make a record.
(6) After finishing the operation, turn the key of the mode switch to the "Teach" side, turn off the dust collector equipment, turn off the gas valve on the protective gas cylinder, release the residual gas in the air pipe, return the robot to zero position, and exit the display. Teach the program, then turn off the power as required, arrange the control cables of the teach pendant, hang the teach pendant at the designated position, and leave after finishing the site.